Trait TxHandlerExt

pub trait TxHandlerExt {
    // Required methods
    fn tx_handler_authorize(
        &self,
        contract: Address,
        header: &TransactionHeader,
        read_slots: &TxHandlerSlots,
        write_slots: &TxHandlerSlots,
        payload: &TxHandlerPayload,
        seal: &TxHandlerSeal,
    ) -> Result<(), ContractError>;
    fn tx_handler_execute(
        &mut self,
        method_context: MethodContext,
        contract: Address,
        header: &TransactionHeader,
        read_slots: &TxHandlerSlots,
        write_slots: &TxHandlerSlots,
        payload: &TxHandlerPayload,
        seal: &TxHandlerSeal,
    ) -> Result<(), ContractError>;
}

Extension trait that provides helper methods for calling TxHandler’s methods on Env for convenience purposes

Required Methods

fn tx_handler_authorize( &self, contract: Address, header: &TransactionHeader, read_slots: &TxHandlerSlots, write_slots: &TxHandlerSlots, payload: &TxHandlerPayload, seal: &TxHandlerSeal, ) -> Result<(), ContractError>

Verify a transaction.

Each transaction consists of a header, payload, read/write slots and a seal.

Payload contains 16-byte aligned bytes, which typically represent method calls to be executed, but the serialization format for it is contract-specific.

Seal typically contains nonce and a signature over transaction header and payload, used for checking whether to allow execution of methods in the payload argument.

In the end, it is up to the contract implementing this trait to interpret both payload and seal in any way desired.

This method is called by execution environment is used for transaction authorization. It is expected to do a limited amount of work before deciding whether execution is allowed or not. Once authorization is granted (by returning a non-error result), execution environment will deduct gas from the contract’s balance and call TxHandler::execute() for actual transaction execution.

It is up to the host environment to decide how much work is allowed here when verifying transaction in the transaction pool as for DoS protection. As a result, requiring too much work may prevent transaction from being included in the block at all (unless user authors the block and include the transaction themselves). Once a transaction is in the block, there are no limits to the amount of work here except the ability to pay for gas.

fn tx_handler_execute( &mut self, method_context: MethodContext, contract: Address, header: &TransactionHeader, read_slots: &TxHandlerSlots, write_slots: &TxHandlerSlots, payload: &TxHandlerPayload, seal: &TxHandlerSeal, ) -> Result<(), ContractError>

Execute previously verified transaction.

Execution environment will call this method with env.caller() set to Address::NULL, which is very important to check! Since there is no code deployed at Address::NULL, only (trusted) execution environment is able to make such a call.

Getting to this stage means that verification succeeded and except charging for gas, no other state changes were made since then. If necessary, it is still possible to do additional checks that would be too expensive or not possible to do in TxHandler::authorize(). It is also important to implement a transaction replay protection mechanism such as nonce increase or similar.

Implementations on Foreign Types

impl TxHandlerExt for Env<'_>

fn tx_handler_authorize( &self, contract: Address, header: &TransactionHeader, read_slots: &TxHandlerSlots, write_slots: &TxHandlerSlots, payload: &TxHandlerPayload, seal: &TxHandlerSeal, ) -> Result<(), ContractError>

fn tx_handler_execute( &mut self, method_context: MethodContext, contract: Address, header: &TransactionHeader, read_slots: &TxHandlerSlots, write_slots: &TxHandlerSlots, payload: &TxHandlerPayload, seal: &TxHandlerSeal, ) -> Result<(), ContractError>

Implementors